Note: Refer to your wiring diagram to know which wire to insert into each cavity. All cavities are marked with numbers to make sure contact is inserted in proper location.

Note: Refer to your wiring diagram to know which wire to insert into each cavity. All cavities are marked with numbers to make sure contact is inserted in proper location.

Check that the Primary Latch Reinforcement (PLR) is in the open position.

Grasp the crimped contact approximately 1 inch behind the contact barrel.

Hold the connector with the rear seal facing you. Insert the contact into the connector cavity until you hear and feel a click. A slight tug will verify the contact is locked in place. Repeat the process until all the cavities are filled.

Note: If you have open cavities, they will need to be filled with an appropriate sized sealing plug.

After all the contacts have been inserted, close the Primary Latch Reinforcement by pushing it into the fully locked position.

Repeat this process for both connector halves.

When mating connectors, grasp the receptacle contact housing by the body and align it with the pin contact housing. Push the housings together until you feel and hear a click.

Push the Connector Position Assurance into the locked position until you feel and hear a click.

Push the Connector Position Assurance to the unlock position.

Depress the locking latch on the outside of the receptacle contact housing and pull it apart from the pin contact housing.